Tuck the camera power/ground wires between the headline and glass. Splicing, soldering, and shrink wrapping your connections is recommended. Step 26Ĭonnect the camera back to the black wire in grounded pin 4 of the factory connect. Use the kit’s tap splice to connect the camera red wire to the reverse-activated power wire in the harness. Locate the reverse-activated power wire in the mirror pine: blue/white wire in pin 9. Route the power and ground wires to the upper center console area. This can be tucked along the headliner and the glass in the a-pillar. Step 22Ĭonnect the RCA to the mirror RCA input. Remove the dash-side panel and route the RCA and camera power/ground wires from the kit up along the a-pillar rail. If you have a handle, remove the two bolts before tugging. The video wires will be covered using the black trim cover included in the backup camera kit. Step 19Ĭarefully cut away and remove the wire sheathing so that the video wires can be paired with the main harness. Important Note: If there is no wire in pin 2, you will also need to add the CAN bus terminal as shown in instructions in kit. Insert yellow and black video wires into connector: yellow to pin 8 and black to pin 16. Remove the terminal lock from the connector and pull off the face of the connector. Remove the overhead trim panel with a hard tug or tool and disconnect the wires. The harness should pull nicely through the indented hole in grommet. Peel back the loom and feed the wire through the grommet. Push the harness through the main wiring grommet by putting a slit in the nipple at the top of the grommet. Route the chassis harness along the frame and come up into the engine compartment next to the brake booster. Both red wires are live when power is applied. Important Note: Remember that the red wire at the rear of the harness is only to be used if you do not want to locate a power source inside the cab. From here we are going to make all of the connections in the cab. Step 11Ĭut off the alternate power supply sure and tuck it inside the harness. Push it in as tight as you can to ensure a good connection. It is keyed and only goes together one way. The opening is located between the bed of the truck and the tailgate.Ĭarefully connect the camera to the chassis harness. Fish the wire through the opening in the back of the bed. Step 8įasten the emblem to the tailgate using the kit’s included body bolts. Pull the cord all the way through and connect the emblem to the body nut clips. Use the kit’s two included body nut clips and push them into the left and right side square openings.įish the kit’s included camera cable through the tailgate and out the opening in the bottom of the Ford F150. Cut the tape away from these holes in a square shape. These are not the holes that the decal fits into. Locate the square holes to the left and right of the center hole. Use a razor knife to cut away tape from center hole as a square. Use fishing line to remove the Ford emblem from the tailgate. The glass breaks very easily and most auto glass companies can do this for free. We recommend working with a professional. Remove the rear view mirror glass prior to starting the project. If you do not have a connector, it is best to use kit CS-FTRa-332 This kit will only work with trucks with an existing 16-pin mirror connector. How To Install A Backup Camera On A Ford F150į-150 backup mirror kit CS-FTR-F35.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |